Trigger Cycle Timer Delay Switch 5V – 24V Circuit Board MOS Control Module AD030

Feature:

Terminal Description:

Function list:

• P-11: Jog (offer signal to relay pull-in, the signal disappears, the relay stop)
• P-12: Self-locking (offer signal to pull, give a signal again to stop relay)
• P-13: Offer signal, the relay will stop automatically for A second; trigger will be invalid during the delay time
• P-14: Offer signal, the relay will stop automatically for A second; trigger re-timing during the delay time
• P-15: Offer signal, the relay will stop automatically for A second; trigger superimposed during the delay time
• P-16: Offer signal, the relay will stop automatically for A second; trigger reset during the delay time
• P-17: Offer signal, relay pull-in, input signal is disconnected, start counting time after A second power off, during the delay period offer signal again to keep output, timing stop
• P-18: When power is on, the relay will pull in immediately and power will be off after A second delay; until the next power-on
• P-21: Offer signal, delay A seconds, the relay pull
• P-22: Offer signal, more than A seconds, the relay pull, the signal disappears, the relay stops
• P-23: After the signal disappears for more than A second, the relay will be closed, the signal will disappear and the relay will stop
• P-24: When the signal exceeds A second, the relay will be closed and the relay will stop after the signal disappears for more than A seconds
• P-25: When the signal exceeds A second, the relay will pull in. If the signal exceeds A seconds again, the relay will stop
• P-26: When the signal pull exceeds A second and stop, signal disappear and relay pull again, after A second stop
• P-27: Detection of pulse signal, the relay stops; no pulse signal, the relay delay A seconds then pull; (continuous signal or signal disappear are regarded as no pulse signal)
• P-28: After power on, after a second delay, the relay will be pulled until it is powered off
• P-31: After power on, relay pull A seconds, off B seconds, infinite loop; power off to stop
• P-32: With signal, start P-31 infinite loop; signal disappears, terminates loop
• P-33: Give a signal, start P-31 infinite loop; give a signal again to terminate the loop
• P-34: After the power on, the relay will pull in after A second delay and will stop after B seconds
• P-35: With signal, delay A seconds later, the relay pull, after pull B seconds stop
• P-36: With signal, more than A seconds, the relay pull, after pull B seconds the relay stop, the signal disappears, the timer cleared to stop
• P-37: With signal, the relay automatically stop A seconds, and then timing B seconds again, duiring A + B signal trigger is invalid
• P-38: With signal, the relay pull A seconds automatically stop, stop re-time after B seconds, again pull A seconds to automatically stop

Package included